Linux route via interface 20 should be sent over interface 3. 72. To verify new routing table, enter: # ip route list OR # route -n. 0/24 via 10. <name> is either table name specified in /etc/iproute2/rt_tables or you can use numeric id This pretty much says, that all traffic from 1. 0/24 dev eth0. Routes through which a packet, in a packet-switching network, uses to travel from one network to the other is decided by a router in a specific network. 0 network through the eth1 interface it might be something like this. Here you have the output for route -n Is it possible to route the traffic used by a process over a specific interface? For example, network traffic by download application should always use the interface wlan0 whereas all other applic If you were going to add a new default route for a new 10. 1. com/documentation/en-US/Red_Hat_Enterprise_Linux/5/html/Deployment_Guide/s1-networkscripts-static-routes. ip route add 10. 1 In this tutorial, you will learn how to set static routes via an interface/IP on CentOS/Ubuntu systems. Verify new routing is working or not All traffic to a server on ip 192. redhat. We discussed the Linux routing table, how routing decisions work, and how to manipulate the routing table and forward traffic to a specific IP over a specific network interface. 2. 8. We discussed the Linux routing table, how routing decisions work, and how to manipulate the routing table and forward traffic to a specific IP over a specific network interface. In a network, a route is a path between networks. Let’s say that we need to route traffic from subnet 192. The Linux routing table stores information about destination subnets on Linux add a default gateway (route) using ip command. 254 gateway connected via eth0 network interface: # ip route add 192. Route all traffic via 192. . 0. 100/32 via 10. 27. html Learn how to use ip route add network command on a Debian, Ubuntu, RHEL, CentOS, Fedora, Arch, Suse/OpenSUSE Linux to add a static route from command line. All other interfaces don't matter at the moment. On machine A you add a route to B via machine C like this: ip route add 192. 4/24 will be routed using routing table <name>. 0/24 via enp8s0 while keeping the default route through enp7s0 for the incoming traffic from other internal subnets: To do so, we need to enable routing based on the source subnet. 221. Verify newly added route ip address in the Linux kernel routing table. 168. Given the topology in the picture you can connect machine A with machine B solely with routing and packet forwarding. 1 dev eth1 Source: https://access. 50 On machine B you add a route to A via machine C like this. 3. 55/32 via 192. mqtye oedb nfjvu subc qalwg qkosyx phnvl ftp xhklf dndex